how to make a brake light bulb replacement and remove the rear light assembly on a hyundai veracruz

by:ILED     2019-12-28
Replacing the brake bulb on modern Veracruz is not a task that is difficult to accomplish at home alone.
However, this is not a simple process, especially since the owner\'s manual gives a good direction but leaves out an important detail.
There\'s a good chance you\'re reading the instructions because you want to know what an important detail is.
First of all, we will change the brake bulb in the actual direction, and I will add this trick when we get to it.
The modern Veracruz I have is a 2008 model, but the instructions are similar for any model year.
You need a cross screwdriver and some wedges to remove some plastic clips.
Here are the instructions for replacing the brake bulb on modern Veracruz. [1894]
Open the tailgate.
Remove the two clips that protect the screws that hold the rear lamp assembly in place.
Then remove the two screws with a cross screwdriver.
Combined light assembly after sliding directly back from the Veracruz body.
Note: This is where it gets tricky and can get you stuck.
For the secret of removing the Assembly of the combined light, see below.
By turning the socket counter-clockwise, remove the socket from the Assembly until the label on the socket is aligned with the slot on the assembly.
Press the socket and rotate the bulb counter-clockwise until the label on the bulb is aligned with the slot on the socket, thus removing the bulb from the socket.
Unplug the bulb from the socket.
Insert the new bulb by inserting it into the socket and rotating it until it is locked in place.
By aligning the label on the socket with the slot in the Assembly, install the socket in the Assembly.
Push the socket into the assembly and turn the socket clockwise.
Reinstall the light assembly to the main body of Veracruz.
How to remove the rear light assembly in modern veracruzmake it doesn\'t take a long time to replace the brake bulb, even if you do it for the first time.
However, with modern Veracruz, you will most likely get stuck trying to remove the rear light assembly.
This is what I found myself in.
I easily remove the screws that hold the assembly in place, but I can\'t get the rear light assembly to slide out as directly as it should.
I found the secret after calling the dealer.
At the front of the light assembly, the back door closest to the Assembly curve, there is a clip.
What you need to do is press the front of the lamp set with one hand and gently pull back the screw with the other, and the whole rear light assembly will slide out directly.
After you remove the rear light assembly, you\'ll see how the attachment works and it\'s easy to figure out how to reinstall the assembly.
Once you \'ve got the hang of pressing in front of the rear light assembly and pulling it back directly from the car, you\'ll find it easy to replace the brake bulb on modern Veracruz.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...