You can easily use the sectional grounding rod to make your electrical fencing stronger. This will help you to protect the domestic animal, which you have in your cattle in a better way. Electric types used in the copper earthing rod are able to produce enough shock to limit the predators if they attempt to cross the boundary. Installation of the sectional grounding rod of conventional types is hard to install. However, these days' companies are making flexible grounding system with easy installation.
First you need to search the best locations for harboring the electric controller that you are going to install in your farm. You must be placing them in a dry location away from wind and rain. In this case, the most recommended areas are garage and the basement. In order to manipulate the electric controller you need to have the polarized outlet at the vicinity.
Now next you need to embed the copper earthing rod into the ground. Its length should be somewhere around six feet and shall be installed around 20 feet within the vicinity of the controller's location. Now you need to connect the grounding wire with the much-assured specifications of 600 to 20,000 volt. Now you have to use a grounding clamp to keep the sectional grounding rod at the place.
In order to maximize the fencing result ground two or more copper earthing rods just 10 feet away from each other. Establish the circuit using the data of chain rods. If you take the advice of any fence contractor then they are surely going to suggest this technique to get the best out of your electric property.
Next you need to install the posts in the mentioned area and a distance of 50 feet, such that they have enough space between themselves. The wires need to be flexible so that the connection does not break. In order to have quicker assembly one can use the post pole digger.
Then next comes the installation of the wiring and in this case you need to use connection that ate resistant to corrosion. You have to check out the dimensions and have to know what is the best space or the specific purpose for which you are using the electrical enclosures.
After everything gets connected the wire rows up to serve the jumper. Now once you finished, connect the wire to the controller and to the top of the wire of the enclosure posts. Before turning of the switch check out all the connections and make sure that the light indicator works properly. At last you need to install the voltmeter to check the voltage and to find out that the electricity runs to length or not.